Bg Network Depth User Manual

CONTENTS GENERAL INTRODUCTION TO B&G NETWORK 2 USING THE LIGHTS KEY 17 INTRODUCTION TO NETWORK DEPTH 3 EXAMPLE SYSTEMS USING NETWOR

USING THE SIGNAL KEY Press the SIGNAL key to display a letter of merit from A to F, this is an indication of the return echo strength. A is excellen

USING THE ALARM KEY 6 Press the ALARM key to cycle through the following options: SHA A M Shallow Alarm, when enabled it will sound if the water de

ENABLING/DISABLING THE SHALLOW ALARM Press ALARM key to display shallow alarm SHA A M.Press SETUP key, the alarm state will be displayed.Press ENTER

ENABLING/DISABLING THE DEEP ALARM Press ALARM key to display deep alarm DEP A M.Press SETUP key, the alarm state will be displayed.Press ENTER key,

6 10-HB-0501-04 14USING THE ANCHOR ALARM The Anchor Alarm uses two adjustable alarm limits. The alarm will sound if the water is deeper or shallower,

ENABLING/DISABLING THE ANCHOR ALARM Press ALARM key to display anchor alarm ANC A M Press SETUP key, the alarm state will be displayed.Press ENTE

610-HB-0501-04 16 ADJUSTING THE ANCHOR ALARM HI LIMIT Press ALARM key to display anchor alarm ANC A M.Press SETUP key 3 times to display ANCH HI valu

610-HB-0501-04 17 USING THE LIGHTS KEY The Network DEPTH Display unit has 3 levels of illumination and off, controlled by the LIGHTS key. It also cha

SETTING THE DISPLAY LANGUAGE The Network DEPTH unit can show LCD text in English or French. To change the display language procede as follows. P

NETWORK ALARMS The Network DEPTH unit has an internal buzzer that willsound when an alarm condition is met on a Network unitthat has alarm functions

GENERAL INTRODUCTION TO B&G NETWORK The B&G Network range of instruments are designed to be used as individual units or connected together t

FAULT AND ERROR MESSAGES NETWORK PILOT FAULT DISPLAY If Network PILOT should have a fault the autopilot computer unit will send a message to all o

INSTALLATION The display heads are supplied with a clip-in mounting bracket which allows for easy installation, access from behind is not necessary t

INSTALLATION DATA GasketBulkheadFit the gasketaround the bracket82.0mm82.0mmMounting Bracket Rubber GasketGasketDisplaySun coverSelf-tapping screwsM

610-HB-0501-04 23 SPECIFICATION PHYSICAL PARAMETERS Construction High impact ABS plastic Window Acrylic Display Back-lit Liquid Crystal Di

INTRODUCTION TO NETWORK DEPTH NETWORK DEPTH DISPLAY UNIT The Network DEPTH unit measures and displays Depth information on a large Liquid Crysta

EXAMPLE SYSTEMS USING NETWORK DEPTH Only one Network DEPTH unit should have a depth sensor connected to it and set to transducer mode. Up to three m

SELECTING THE DISPLAY MODE The Network DEPTH unit has two operating modes. The correct mode must be selected for your network system to operate prop

610-HB-0501-04 6 USING THE DEPTH KEY Press the DEPTH key to cycle through the following options: • DEPTH M The current water depth in metres M, can

SETTING THE DEPTH UNITS The Network DEPTH unit can be set to display depth in Metres M, Feet FT or Fathoms FA. The selected units are used for displ

THE DEPTH DATUM - D CAL The depth datum D CAL is an offset calibration value used to determine the displayed information reference point. It is add

SETTING THE DEPTH DATUM D CAL zero, depth from transducer CAL TRA. D CAL positive, depth from waterline CAL W/L. D CAL negative, depth from keel CAL